Submersible Well Pump Accessories

Well Pump Accessories

Submersible Well Pump Accessories. Torque Arrestors, Submersible Pump Cable, Well Seals, Bronze Pitless Adapters, Franklin Electric Pump Control Boxes, Sprinkler Timers, Strataflo Bronze Check Valves, Flo-Control PVC Check Valves, Pressure Switches, Liquid Filled Pressure Gauges, Wellmate Fiberglass Pre-charged Bladder Water Pressure Tanks and Pressure Relief Valves.


Heat Shrink Cable Splicing Kits

These 4 wire, black, heavy wall heat shrink splicing kits can be shrunk over a large diameter connector and still effectively seals watertight to a small diameter cable. Four butt connectors are included.Slip shrink tube on each wire, crimp connector on each wire, center tubing over connector and heat from center outward, splice is complete when sealant flows fron end of tube. Do not overheat

Torque Arrestor TA-48

Torque arrestors are clamped on the submersible well pump drop pipe and are field adjusted to hold the pump centered in the well casing. Fits 4"-8" well casings and 1 or 1-1/4 drop pipe.

 Pitless Well Adapters

Bronze pitless adapters to insure long life and durability in the most aggressive well conditions. External installation nipple makes installation easy.Rubber inner & outer casing gaskets for certified & approved water tight seal from ground water contamination.

Well Seals

Cast iron well seal with rubber packing gland for submersible and jet pumps. Prevents contamination from surface drainage. Easy to install, just fit in casing and tighten bolts. Corrosion resistant zinc plated steel bolts. Painted finish. Split top

Well Caps

Cast Aluminum standard ventilated well cap with conduit opening. Standard 4". 5" and 6" cast aluminum well caps for use on steel or plastic casiing. Stainless steel set screws

Submersible Well Pump Cable

Submersible pump cable 12/4 (3-wire plus ground) UL listed 3 wire copper cable (with ground) for use within the well casing supplying power to the submersible pump.

Strataflo Noiseless Check Valves - Brass Spring Loaded<br>

Strataflo bronze spring loaded check valve. For cold water service to retain liquid in a system preventing loss of prime when liquid source is lower than pump. It prevents backflow by allowing liquid to flow in one direction only.

Pressure Relief Valve 1/2" (Set 100 PSI) # IRV50-100NL (D)

Pressure relief valve 1/2" heavy duty, no lead, bronze pressure relief valve for shallow, deep well and submersible pumps. Recommended only for cold water system installation. Spring loaded and pre-set at 100 PSI (Not adjustable). Not for use with hot water heaters.

WellMate Fiberglass Bladder Water Pressure  Tanks

WellMate fiberglass bladder water pressure tanks are quicker, easier and less costly to install than steel tanks. They contain no steel, so there is no paint to scratch or touch-up and they cannot rust. All component materials are NSF and/or FDA listed. Factory 5 years warranty period for potable water residential installations and 2 years for non-residential installations.

Liquid Filled  Pressure & Vacuum Gauges  2"

Glycerine liquid filled 2" , 1/4" MNPT bottom connection, 2% accuracy, vacuum and pressure gauges with steel case and plastic lens for high vibration applications in 30 to 160 degrees Fahrenheit temperature.Use only with water

Pressure Switches

The pressure switch starts and stops the pump motor automatically at a predetermined pressure. A tube connects the switch to some point in the system on the discharge side of the pump. The pressure in the system then acts directly on a diaphragm in the switch, which in turn actuates the contacts in the switch.

Franklin 4", 3 Wire, 1 Phase, 60 Hz Submersible Well Motors & Control Boxes <br>

Franklin Electric Motor 4", 3 wire, single phase, 60 Hz, 1/2 HP to 5 HP,water cooled, submersible water well motors with 48" Leads and control boxes. Single phase three-wire submersible motors require the use of control boxes.

 Monodrive Variable Speed Controller

Franklin Monodrive variable speed constant pressure controllers are designed to provide constant pressure for single-phase, three-wire submersible water well pump systems. You can have constant pressure just by replacing the three-wire control box in a conventional system.

PumpTec Controls

PumpTec Automatic Protection Control For Franklin Submersible Motors, Single-phase, solid state, load monitoring devices designed specifically for Franklin submersible motors to protect from running dry. They protects the life of 4" submersible pump and reduces the odds of ever having to see the motor again

Electrical Slicing Tape

The tape method was the only way to make a good splice until shrink tube splice kits became available. Many installers still use tape because it has worked for them for years. You crimp the conductors together, wrap each conductor with a layer of rubber tape followed with a layer of plastic electrical tape. This makes a watertight connection and insulates the conductors from each other and the well casing. Properly done, this technique makes an excellent splice, but is very time consuming.

Sprinkler Pump Timers <br>

Intermatic 24 Hour Electric Sprinkler Timer. Rainproof enclosure with provision for rain sensor. Built-in pump start relay. On-off switch allows for shutdown during rainy days. 14 day skipper wheel permits watering to be omitted on selective days.

Questions & Answers

Ask a question about Well Pump Accessories. Click here
Customer Reviews



About Us Contact Us Customer Reviews Facebook Twitter Disclaimers Privacy Policy Returns Shipping Policy Terms of Sale Terms of Use Warranty FAQ Site Map Technical Info Terminology Troubleshooting
  • Internet prices apply only to Internet purchases.
  • Minimum order amount is $20.00.
  • All merchandise listed is in stock.
  • Orders are shipped the next business day.
  • We only sell within the 48 adjacent United States.
  • Shipping tracking numbers are e-mailed automatically.
  • Office hours are: Mon - Fri, 8am - 4:30pm EST excl. holidays.
Copyright © 2024 All Rights Reserved.